Then, I dip it into alcohol and I put it into the console connectors in an in-and-out movement. The most concentrated you can find, really.įor female cartridge connectors (the connectors inside the consoles), I usually take an old plastic gift card and I wrap up a piece of fabric around it (make sure the fabric that you choose won't leave any kind of string coming off of it into the connector). Get some 70% or 90% alcohol, or even some 50%. And if you can unscrew it, alcohol is fine :). And for the eraser part, do it only if you have the special nintendo security screwdrivers to unscrew the cartridge, otherwise it is too much of a pain. I then clean them using alcohol and a Q-tip.
I tend to VERY gently rub a pencil eraser on the contacts, as it removes the oxidized layer on the contacts. Some people will tell you that scrubbing is the best, others will say that rubbing/isopropyl alcohol makes the contacts rust. Ling story short my 1.5K Board is fine and isopropyl is S+ teir safe for cleaning electronics case closed. 70% grade from soaking up moisture it will still evaporate at room temperature almost instantly. (It sucks water up like a super sponge but unless it’s at like.
Even removing heat syncs cleaning off them and the thermal paste (replaced it after of course!!) inbetween and under every diode capacitor every single relay followed the leads from start to finish etc etc scrubbed the infrastructure let it dry (takes about 2 seconds since it is miscible with water then will evaporate at room temperature because the kinetic energy at room temperature is enough to overcome attraction of the molecules causing them to disburse into the air rather then stay a liquid. Hi I have a RTX 3060 graphics card in my rig my daughter managed to spill coffee on it i immediately disconnected all power removed internal battery and proceeded to clean the entire board top to bottom LITTERALLY TOP TO BOTTOM BOTH FKING SODES….
0 kommentar(er)
